Engineer

Company :

Inokom Corporation Sdn. Bhd.

JOB CONTENT

1.To coordinate personnel between the various department for process and parts validation during new model introduction.

2.To studies on jigs, stays and Paint Shop equipment for new model introduction.

3.To conduct feasibility study of existing Paint Shop for new model introduction and process methodology to ensure the production efficiency.

4.To ensure that the assembly or production Work Instruction (WI) are established and up to date for all vehicle models

5.To participate with various supporting department and to develop good communication networks to ensure smooth production activities during any new model introduction before mass production. 6.To control and manage the administrative activities within department including control of documents.

7.To control and monitor in term of process, quality and else through process audit.

8.To execute the General Duties of Employer under part IV Section 15 of Occupational Safety and Health Act (OSHA 1994) and Environmental Quality Act (EQA 1974).

9.To perform any other task assigned by the superior from time to time.

About us :

Inokom is involved in the assembly and manufacturing of light commercial vehicles as well as contract assembly. Its manufacturing facility is located in Padang Meha, Kulim, occupying 200 acres of freehold land. Production first commenced in August 1997.The Company is owned by a consortium of corporate shareholders, which constitutes of Sime Darby Motors Sdn. Bhd., Sime Darby Hyundai Sdn Bhd, Hyundai Motor Company of South Korea , and Berjaya Auto Berhad.