Sheetmetal Mechanic - RTP

QUALIFICATIONS:

• •Able to understand all aspects of HVAC installation.
• •Be dependable and able to work different areas at a time with 4-5 people in each group.
• •To be able to lay-out duct for installation and look ahead to keep work going smoothly.
• •Employee must have a good working attitude.
• •Needs to adhere to all EAS safety policies and regulations.
• •Must be capable of spotting unsafe situations and correcting them as needed.
• •Has to be able to sketch fitting for duct connections. Have knowledge of signals for rigging, and setting HVAC equipment with cranes, boom trucks, lulls, and forklifts.
• •Have knowledge of Welding and fabrication of supports for equipment.
• •Needs to know Air flow of systems as far as—Supply; Return; Exhaust.
• •Needs to be able to do Quality Control to make sure that all HVAC inline Mechanical Devices are installed according to Manufactures Instructions.
• •Needs to be able to work with other Trades in a Professional manner to correct any conflicts that may arise.
• •Capable of reading not only duct work drawings, but Architectural drawings to locate rooms, ceiling elevations, columns.

EDUCATION:

• •Minimum of a high school education or equivalent.
• •This Position requires a minimum of five (5) years of Sheet Metal experience.

JOB REQUIREMENTS/SPECIAL SKILLS:

• •Requires working in conditions of varying heat and cold and where noise levels are at or above 90 decibels.
• •Courses in construction safety are a requirement.
• •Be able to continue job if Superintendent is not available.
• •Ability to lift up to 50 lbs.