hirly

PM CNC Technik & Schulungs GmbH

Buchhalter/in

Trofaiach, Steiermark, Austria

See how you match this job — and similar ones. Free.

Upload your resume and hirly scores it against this role at PM CNC Technik & Schulungs GmbH first, then against similar open jobs, and shows where you fit and why.

PDF or DOCX, up to 12MB. No sign-up to see your matches.

Get past the screening software and onto a recruiter's desk

hirly rewrites your resume for this job — matching the keywords and skills in the posting, moving your most relevant experience to the top, and writing a cover letter to fit. About 30 seconds.

  • Keywords matched to this posting
  • Fit score before you apply
  • Cover letter included
Tailor my resume for this job →

Apply from your AI assistant

Connect hirly to Claude and ask it to apply to this job. hirly tailors your resume, fills the employer’s form and asks before sending. ChatGPT: manual setup today.

Some employer sites stop an application at a CAPTCHA or sign-in and hand it back with a link. Applying needs a paid plan. Works with any assistant that supports MCP.

hirly's read of this role

Role family
Finance
Seniority
Mid level
Country
AT
Work mode
On-site / unstated
First seen by hirly
26 Sept 2026

Derived automatically from the posting. Upload your resume above to see how the role scores against it.

the posting

Teilzeit (10 - 15 Wochenstunden vormittags bzw. nach Vereinbarung)

Ihre Aufgaben:

  • Berichtswesen
  • Debitoren / Kreditorenbuchhaltung
  • Mahnwesen
  • Erstellung der Monatsabschlüsse
  • Personalverrechnung
  • Statistikerstellung
  • Zeitmanagement
  • Datenpflege

Was sollten Sie mitbringen:

  • EDV-Kenntnisse (ECDL von Vorteil)
  • BMD Kenntnisse von Vorteil
  • Eigeninitiative
  • Kommunikationsstärke

Geboten wird:

  • eine gründliche Einschulung
  • attraktive Arbeitszeit
  • sehr gutes Betriebsklima
  • Überzahlung je nach Qualifikation und Praxis

Bitte richten Sie Ihre aussagekräftige Bewerbung inklusive Lebenslauf mit Foto per E-Mail bei Herrn Michael Pfandlbauer unter [email protected]

  • PM CNC Technik & SchulungsGmbH
  • Gewerbepark Nord 1
  • 8793 Trofaiach
Original posting on PM CNC Technik & Schulungs GmbH's site ↗

Listed on hirly, a job board. hirly is not the employer: PM CNC Technik & Schulungs GmbH is hiring for this role.

Want this one?

Upload your resume and hirly rewrites it for this job and writes the cover letter — in about thirty seconds, before you sign up.

Tailor my resume for this job